This category is for our high pressure misting pumps if you need an individual part by itself

Showing 1–24 of 30 resultsSorted by popularity

Low Pressure Switch

Low Pressure Switch with 3/8″  inlet/outlet to make sure the pump doesn’t turn on when the water pressure is to

Pump Cover (Hard)

Plastic pump cover will greatly increase the life of your pump, and recommended for ALL installations where the pump will be outdoors in the rain.

Fully Assembled Cycle Timer with Remote

Cycle Timer with Remote turns a standard pump that turns Off and On with the power switch, into a Pump

0-4 GPM Regulator

Max GPM: 4 Max PSI: 2600 Inlet: 3/8″ F NPT Outlet: 3/8″ M NPT Pump Series: RC Plunger Pumps Features

Cycle Timer with Remote

Oour remote control works up to 800' away!

Cycle Timer Remote

New for 2014 our remote control works up to 800' away! and controls up to 1.5 hp motors aka 2 gpm pumps!

1/2 HP Motor

1/2 horse power motor, 56 C face, 115volt / 208 - 230 volt, comes standard as 115volt special arrangements need to be made for 220v needs, 60hz, Totally Enclosed Fan Cooled, 1800 rpm 4 pole, Draws 8.8 amps at full load 115v and at 220v 4.9-4.4 Amps respectively, keyed shaft 27 lbs, 1.15 service factor, continuous duty cycle, comes with TWO YEAR nameplate warranty longest in the industry! If under reasonable wear and tear motor fails to spin within the first 2 years send us back the nameplate and we will issue you a new motor plus shipping and handling

Brass Regulator

This regulator serves as a flow proportionate valve. With this pressure regulating operational regulator valve, you are assured of top

1/4″ Short Barstock Street Elbow

1/4″ MPT x 1/4″ FPT Short BarStock Street Elbow

10004 – Kit B, Valve and Seals, for the Pumptec pump

Valve & Seals for the 112T / 113C / 112V / 217V / 350U / 360U   4 – Valve

7 GPM Pump Head

7 GPM high pressure pump head only.

10034 – Kit A, Ceramic Plunger & Buna Seals

Ceramic Plunger and Seals for 113C   1 – Ceramic Plunger 2 – U-Cup 2 – Support Rings 2 –

Thermal Relief Valve

The TPP140 Thermal Relief Valve Series are mounted into the low pressure side of the pump manifold and will vent

5 HP Motor – Single phase

5 HP Motor – Single Phase Standard Features – Manual Reset Protectors – High Efficiency Dual Cap Design – High

Power Cord – 9 ft

9 Foot 16/3 cord with U Ground NEMA 5-15 plug and pigtail end Rated For: 13 Amp, 125V, 1625 Watts

3 HP Motor – Single phase

3 HP Motor – Single Phase Standard Features – Manual Reset Protectors – High Efficiency Dual Cap Design – High

4 GPM Pump Head

4 gpm high pressure pump head only, max psi 3000 with proper motor, 1750 rpm 1 1/8" hollow shaft Nema c face electric motor flange, 15mm piston